12 Volt

Vector Smart Chargers GoPower Smart Chargers Peak Battery Chargers Soneil Low Power Chargers Soneil Medium Power Chargers

24-72 Volt

Soneil Low Power Chargers Soneil Medium Power Chargers
All models Golf car models Electric Vehicles/Battery Banks Forklift/Lift Trucks/Traction Marine/RV/Shop Use/Vehicles BatterySolver Packages
Vector Inverters Peak Power Inverters Thor Inverters

GoPower

Solar & Inverter Charging Kits Inverters: Pure Sine Wave Inverters: Modified Sine Wave Inverter Accessories Inverter Install Kits
Vector Jump Starters Peak Jump Starters

GoPower

Solar Charging Kits Solar and Inverter Charging Kits Solar Panel Mount DURAlite Solar Modules

Vector

Accessories Storm Tracker

GoPower

Digital Charge Controllers Inverter/Charger Accessories Fuse Block Fuses

Peak

Rechargeable Lights Rear Cameras Accessories

Currently viewing: The BatterySolver™ Package

PACKAGE PRIMARY USE

The package is used primarily for storing a battery or batteries seasonally. The package can be installed on board in a permanent installation. An example would be a collector car, motorcycle, RV, boat or any other vehicle that is used seasonally.

This package consists of

  1. The Battery Life Saver™ electronic device BLS-12/24B (Package also available for 24, 36, 48, and 72 volt systems)
  2. A Vector 2 amp float charger and
  3. A timer to cycle the charger on and off daily.

The charger and The Battery Life Saver electronic device can be mounted on a vehicle as needed.
This package will keep your batteries in a like new condition during the entire period of
storage. It can also be used to rejuvenate dead batteries easily.

Timer and BLS

Theory of Operation

The Battery Life Saver electronic device (BLS) restores and maintains a battery in a like new condition by using a radio signal to dissolve lead sulfate crystals that build up on its plates.

The plates consist of stacks of multiple flat plates that provide a high surface area on which to generate the electricity. They alternate from positive to negative in the stack.

Sulfate builds up on both the positive and negative plates. In order for the Battery Life Saver to dissolve the sulfate crystals from both plates it must operate while it discharges the battery AND while the charger is charging.

This is why the timer is used. To allow the BLS to work during the charge cycle and the discharge cycle.

Instructions Page

Installation Page

12 Volt BatterySolver Package(Indoor Timer): $145.00

12 Volt BatterySolver Package(Outdoor Timer): $160.00

We also offer the BatterySolver Package for 24, 36, 48, and 72 volt battery systems. Click here to review our Catalog

Here are prices on the BatterySolver Package

Item Price
BLS-12-B $119.95
VEC080 $34.99
Indoor Timer $9.95
 
Total Price $164.89
   
Package $145.00
   

*For an outdoor timer instead of an indoor timer add $15.00

We offer the BLS-12/24-B because it is the best BLS to recondition dead batteries.

*NOTE: If you wish to order either of the above please first go to either the Battery Life Saver Catalog page or the Vector Charger Catalog page and add the item to the cart there.

 

Vector Products Customer Service # 1-800-618-5178
For Vector Products Support and Customer Service, please contact Black & Decker at 1-800-618-5178. Select the "Customer Option", then state the word "Operator" to speak to someone quickly. Their hours are 8 a.m. to 4 p.m. EST.


Battery Life Saver Contact Information

Email: bls @ batterylifesaver.com

Phone: (727) 446-8400
Toll Free: 866-301-8835
Fax: (727) 446-8900

936 Cleveland St. Unit C, Clearwater, FL 33755

Designed by Danstrog

2003-2010 © INVENTIONEERING®. All Rights Reserved.


INVENTIONEERING® is a registered trademark owned by Charles A. Van Breemen
The BATTERY LIFE SAVER™ electronic device is a trademark owned by INVENTIONEERING® and is used with its permission.